Eaton PowerXL DC1 20 Series Installation Manual page 189

DC1 1 2 3
1 2 3
Figure 93: Block diagram DXC-EXT-2RO
Parameter Definition
The K1 relay output's function can be configured using parameter P-18
(default setting = 1: RUN). Meanwhile, the new K2 relay output's function
can be configured using parameter P-25 (default setting = Analog output
AO1).
￫
Parameter P-25 must be set to a value between 0 and 7 in order
for the output to function as a digital output.
If the parameter is set to a value greater than 7, relay output K2
will not work properly.
DC1...20... and DC1...OE1 Variable Frequency Drives 02/20 MN040059EN www.eaton.com
4 5 6 7
4 5 6 7
f-Soll
4.7 kΩ
7 Accessories
7.1 Device-specific accessories
P-25 P-18 = 1
RUN
8 9 10 11
8 9 10 11
K2 K1
250 V AC
220 V DC
≦ 1 A
185