Eaton PowerXL DC1 20 Series Installation Manual page 71

3.3.3.2 Fixing on a mounting rail
As an alternative to screw fixing, DC1 variable frequency drives with sizes
FS1, FS2 and FS3 and a degree of protection of IP20 can also be mounted on
a mounting rail as per IEC/EN 60715.
￫
If you use EMC mounting adapters (DX-EMC-MNT-...), use a tall
mounting rail (15 mm) preferably.
Figure 28: Mounting rail conforming with IEC/EN 60715
￫
If you use EMC mounting adapters (DX-EMC-MNT-...), use a tall
mounting rail (15 mm) preferably.
▶ To do this, place the variable frequency drive on the mounting rail from
above [1] and press it down until it snaps into place [2].
1
2
Figure 29: Fixing on a mounting rail
DC1...20... and DC1...OE1 Variable Frequency Drives 02/20 MN040059EN www.eaton.com
1
0.04"
7.5
0.29"
15
0.59"
EMC
VAR
3 Installation
3.3 Mounting
67