Dc1-12 - Eaton PowerXL DC1 20 Series Installation Manual

3.7.2 DC1-12...

①
DC-
FS2,
FS3
DC+
BR
U
R
B
Mains voltage U
Motor voltage U
Size: FS1, FS2 and FS3 with IP20 degree of protection
1 AC 200 - 240 V
50/60 Hz

L1/L L2/N
②
EMC

V W
PES
3 AC 230 V
M

3 ~
Figure 64: Block diagram DC1-12...
Variable frequency drive with single-phase supply system voltage and three-
phase motor connection
① Devices with a frame size of FS2 or FS3 allow for DC link coupling
(DC+, DC-) and connecting brake resistors (DC+, BR).
Brake resistor DX-BR3-100 can be inserted underneath the heat sink into
the enclosure and electronically protected against overloads (P-34 = 1).
② DC1-12xxxN...: without radio interference suppression filter
DC1-12xxxF...: with built-in radio interference suppression filter
DC1...20... and DC1...OE1 Variable Frequency Drives 02/20 MN040059EN www.eaton.com
: single-phase, 200 (-10 %) - 240 (+10 %) V, 50/60 Hz
LN
: 3-phase, U = U
2 2 LN
1 2 3 4
, 0 - 50/60 Hz (max. 500 Hz)
5 6 7 8
CPU
3 Installation
3.7 Block diagrams
9 10 11
RS485
X1
Modbus RTU
CANopen
OP-Bus
109