Software Operation Modes; Sample List Operation Mode; Macro Operation Mode - Teledyne T3SP Series Operator's Manual

file access permissions.
•
Self-Test: Perform a device self-test.
•
Please note: generally the advanced tab is password protected. After
program installation the password is empty. Once the password is
given correctly the protection is turned off until the Seunis program
is closed. Use the ALT-P shortcut to reactivate it immediately. In case
you have lost your password please contact

2.6 Software Operation Modes

The software provides three different operation modes; sample list mode
(default), macro mode and quick mode. Each of these modes can be se-
lected via the corresponding toolbar icons shown below:

2.6.1 Sample List Operation Mode

The sample-list mode is the default operation mode. It is activated on pro-
gram startup and/or by clicking the sample-list item in the toolbar. The
functionality was already described in section 2.6.1. Furthermore measure-
ments made in macro operation mode (cp. section 2.6.2) can be edited in
this mode after exiting the macro operation mode

2.6.2 Macro Operation Mode

In case the same sequence of measurements (optionally with different mea-
surement modes or different impedance settings) has to be repeated over
Sample List Operation Mode
Macro Operation Mode
Quick Operation Mode
T3SP-Series Operator's Manual
Teledyne LeCroy
(2.6.1)
(2.6.2)
(2.6.3)
support.
20
931776 RevB