Teledyne T3SP Series Operator's Manual page 18

Fig. 4: The Common tab in the Options Dialog
Device tab:
•
In most cases the software is started with a connected device and it is
intended to connect automatically. However if the software shall be
started with a Viewer Key it is possible to deactivate the Auto-Connect
on Startup.
•
Data Rate: data transfer rate between device and software (read only)
•
The Single Shot Measurement box should be checked, if all average
measurements shall be carried out at once. Otherwise all measure-
ments can be performed separately. This may be desirable in some
very specific applications. By default this option is turned on.
•
In some rare cases it may be necessary to switch off the instable signal
protection during measurements, there for the Ignore Instable Signal
T3SP-Series Operator's Manual
18
931776 RevB