Table of Contents
Advertisement
Please note: for displaying traces of multiple measurements in the result vi-
sualization window, highlight these in the spread sheet of the main window
by holding the CTRL-key pressed. The legend shows the colored sample indi-
cators accordingly.
18.
For zooming use the mouse and/or the toolbar buttons. An auto-
zoom function is available and can be activated by pressing the tool-
bar button
to the current oscilloscope zoom by clicking the lock symbol in the
toolbar.
19.
Data can be exported in different formats by the menu item File
Export or the disk symbol (toolbar) in the Result Visualization Win-
dow.
20.
For further sample settings (e.g. impedance mask, signal velocity,
etc.) please refer to section 5.1.3.
21.
After completing a measurement, switch to the next line of the sample
list and create a new sample if necessary.
22.
If all samples have been measured, save your work via the menu File
Save As in the Main Window. All data and calibration data will be
stored in a project file (*.sqc) and can be reloaded afterwards.
23.
It is possible to change sample properties for multiple samples at once.
This can be done by selecting multiple sample (CTRL-key & select) us-
ing the menu entry Extras
Window or by right-clicking the selected samples.
. Alternatively the zoom can automatically be adjusted
Change Sample Settings in the Main
T3SP-Series Operator's Manual
29
931776 RevB
Advertisement
Table of Contents
