Table of Contents
Advertisement
T3SP-Series Operator's Manual
General Remark
The Oscilloscope Window gives the user an overview over the current device
setting (average, time base settings) and shows the real-time ("live") TDR
trace(s), similar to an oscilloscopes screen. If a measured sample is selected
in the main window additionally the corresponding uncorrected TDR trace(s)
is/are displayed.
Number of Averages
The number of curves to be averaged (repetition measurements) for a sam-
ple can be set in the Average field. In case a large number of averages is
chosen it may be advantageous to display only an averaged version of the
trace(s). This can be activated via the menu entry View
Display averaged
Measurement.
Please note: in the Seunis.config file a maximum number of averages can
be set (Compressed number of measurements, default: 50). If the selected
number of averages exceeds this number, the number of stored repetition
measurements is compressed to this value automatically.
TDR and Impedance View
The view can be switched to real-time impedance trace (menu View
Show
Impedance). The impedance trace represents the uncorrected (without three-
term correction) impedance. The traces of the currently selected sample in
the sample list are not shown if impedance is turned on.
The live traces can be switched on/off via the Channel buttons. A linear inter-
polation between the points can be activated via View
Interpolate Trace.
The background color can be changed via the View
Change Background
Color menu entry.
12
931776 RevB
Advertisement
Table of Contents
