Csv-Export Module - Teledyne T3SP Series Operator's Manual

Summary table:
ments.
Diagrams:
measurements and additional details in side-tables.
Group statistics:
software groups the measurements respectively and shows additional
information for these groups (mean/min./max. impedance and stan-
dard deviation, pass/fail).
Please note: some specific information for the PDF export can be switched
on/off in the Advanced tab in the Options Dialog (see section 2.5.4).
2. S /DS Measurements: The (differential) reflection coefficient DS
11 11
are exported to two diagrams: the magnitude (in dB) and the phase
vs. frequency.
Please note: measurements of different kinds (e.g. TDR/S11) cannot be combined
into a single PDF file. In this case the measurement mode of the first selected sample
is chosen and all samples with different measurement modes are ignored. However
single-ended and differential measurements in similar modes can be exported into
the same PDF.

6.2 CSV-Export Module

For this export module two different modes are available. If the sample list
only contains TDR/DTDR measurements, a summary table similar to the
PDF-export is generated. In all other cases, only a summary of the mea-
surements similar to the sample list including some additional information
is created.
Please note: the CSV delimiter can be changed in the Seunis.config file (see section
2.2).
List showing the results for the individual measure-
Impedance traces (incl. tolerance masks) for individual
The user can specify criterions (dialog appears). The
T3SP-Series Operator's Manual
/S
11 11
50
931776 RevB