Inserting And Removing Devices; Inserting The I/O Module; Figure 7: Insert I/O Module (Example); Figure 8: Snap The I/O Module Into Place (Example) - WAGO I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-484 2AI 4-20mA HART Ex i
5.2

Inserting and Removing Devices

Perform work on devices only if they are de-energized!
Working on energized devices can damage them. Therefore, turn off the power
supply before working on the devices.
5.2.1

Inserting the I/O Module

1. Position the I/O module so that the tongue and groove joints to the fieldbus
coupler/controller or to the previous or possibly subsequent I/O module are
engaged.

Figure 7: Insert I/O Module (Example)

2. Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.

Figure 8: Snap the I/O Module into Place (Example)

With the I/O module snapped in place, the electrical connections for the data
contacts and power jumper contacts (if any) to the fieldbus coupler/controller or
to the previous or possibly subsequent I/O module are established.
Mounting 43
Manual
Version 1.4.0