Startup On The 75X-Xxx Via Plc Library; Figure 22: Communication Example On The 75X-8Xx Controller Via Wagolibhart_0X.lib; Table 48: Required Software For Startup On 75X-Xxx Via Plc Library - WAGO I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-484 2AI 4-20mA HART Ex i

Figure 22: Communication Example on the 75x-8xx Controller via WagoLibHART_0x.lib

More information about the application
You can read a detailed description with a clear application example for the
"WagoLibHART_0x.lib" library with WAGO-I/O-PRO CAA in the respective
application note that describes the HARD application using this library.
You can download this application note from the WAGO homepage at:
www.wago.com
Enter the search term "WagoLibHART".
9.1.2

Startup on the 75x-xxx via PLC Library

This section describes the most important steps for commissioning the HART I/O
module on a 75x-xxx fieldbus coupler/controller using the HART library.
In addition to the fully installed and connected hardware of the fieldbus node with
fieldbus coupler/controller interface, it is necessary to install the following
software before carrying out the operation described.

Table 48: Required Software for Startup on 75x-xxx via PLC Library

No. Software name
1 WAGO-I/O-CHECK
(optional)
2 WAGO-I/O-PRO CAA
3 WagoLibHART_0x.lib
When the HART I/O module is delivered, the default operating mode (2 AI + 6-
byte mailbox) is preset.
If the operating mode has already been changed, e.g., the module has been
used in a PROFIBUS system, the operating mode must be parameterized again
for the default setting
Description
Commissioning tool for the
WAGO-I/O-SYSTEM 750
Programming tool IEC
61131-3; CAA Version
2.3; CODESYS
Automation Alliance
WAGO-I/O-PRO Libraries Download:
Commissioning 67
Item number
759-302
759-333
www.wago.com
Manual
Version 1.4.0