Commissioning On A 750-333, -833 Via Fdt/Dtm; Table 51: Software Required For The Commissioning On A 750-333, -833 Via Fdt/Dtm - WAGO I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-484 2AI 4-20mA HART Ex i
9.3.2

Commissioning on a 750-333, -833 via FDT/DTM

This section describes the most important steps for commissioning the HART I/O
module on a PROFIBUS DP/V1 Fieldbus Coupler (750-333) or Controller (750-
833) using FDT/DTM.
Along with the installed and wired fieldbus node hardware, which includes the
PROFIBUS DP/V1 Fieldbus Coupler (750-333) or Controller (750-833), it is
necessary to install the following software before carrying out the operations
described.

Table 51: Software Required for the Commissioning on a 750-333, -833 via FDT/DTM

Pos. Name
1 WAGO-I/O-CHECK
(optional)
2 GSD files for PROFIBUS
with installation program /
Series 750, 752 and 755
3 WAGOframe
4 WAGO_Profibus_HART
_DTM 759-360
5 WAGO_075x-08xx_DTM
6 HART device DTM(e.g.,
Generic HART DTM from
ICS GmbH)
1. As is typical for a PROFIBUS application, set up the operating mode "2 AI +
acyclic PROFIBUS services" using the GSD files. You will find more
detailed information on this in the section "Operating Modes" > ... > "Setting
Up via GSD".
Alternatively you can also open WAGO-I/O-CHECK if available. In this
case, proceed as described in the section "Operating Modes Parameters"
> ... > "Setting Up using WAGO-I/O-CHECK".
2. Open WAGOframe in "Expert mode".
3. Next make sure that the "Device catalog" dialog window is shown on the
right-hand side of the screen. This must be activated under Device catalog
on the View menu.
Click on [Update] in the "Device catalog" dialog window.
4. Open a new project using New on the File menu.
5. Make sure that the "Network view" dialog window is shown on the left-hand
side of the screen. This must be activated under Network view on the
View menu. Now move the mouse to Network in the tree structure and
Description
Commissioning tool for the
WAGO-I/O-SYSTEM 750
Fieldbus-specific software
(e.g., GSD files for
PROFIBUS)
FDT frame application for
parameterization,
commissioning and
diagnostics of devices with
DTM device drivers
DTM for PROFIBUS
DTM for the 75x-8xx
controller
DTM for parameterization,
commissioning and
diagnostics of HART-
enabled field devices
Commissioning 75
Item-No.:
759-302
750-910
Download:
www.wago.com
759-370
759-360
Both Download:
www.wago.com
Obtainable from
HART field device
manufacturers
Manual
Version 1.4.0