Commissioning; Parameterization With Wago-I/O-Check - WAGO 750-496 Manual

8ai 0/4-20ma s.e., 8-channel analog input; 0/4-20 ma, single-ended

Hide thumbs Also See for 750-496:

Table of Contents

Commissioning

7.1

</dg_

The WAGO-I/O-CHECK software from WAGO Kontakttechnik GmbH & Co. KG

can be used to conveniently and completely configure and parameterize the I/O

module. You have the following options.

•

Graphical display of bus nodes

•

Display of the measured values

•

Settings for the application

•

Configuration of the I/O module operating modes

•

Parameterization of module, channel and scaling settings

•

Calibration of channels and adjustment of analog inputs

•

Monitoring

WAGO-I/O-CHECK

You can obtain the WAGO-I/O-CHECK software on a CD under Item No. 759-

302. This CD contains all the application program files and an explanation. You

can find a description at the internet page at

Save all your settings before you begin parameterization!

To be on the safe side you should always save all of your current settings in a

parameter file before you begin parameterization. This enables you to always

use the original values, should any parameters you are defining not be correct.

Manual

Version 1.2.2

WAGO-I/O-SYSTEM 750

750-496 8AI 0/4-20mA S.E.

http://www.wago.com

Table of Contents

Table of Contents