WAGO-I/O-SYSTEM 750
750-484 2AI 4-20mA HART Ex i
1
Notes about this Documentation
Always retain this documentation!
This documentation is part of the product. Therefore, retain the documentation
during the entire service life of the product. Pass on the documentation to any
subsequent user. In addition, ensure that any supplement to this documentation
is included, if necessary.
1.1
Validity of this Documentation
This documentation is only applicable to the I/O module 750-484 (2AI 4-20mA
HART Ex i) and the variants listed in the table below.
Table 1: Variants
Item Number/Variant
750-484
750-484/000-001
The I/O module 750-484 shall only be installed and operated according to the
instructions in this manual and in the manual for the used fieldbus
coupler/controller.
Consider power layout of the WAGO-I/O-SYSTEM 750!
In addition to these operating instructions, you will also need the manual for the
used fieldbus coupler/controller, which can be downloaded at www.wago.com.
There, you can obtain important information including information on electrical
isolation, system power and supply specifications.
1.2
Copyright
This Manual, including all figures and illustrations, is copyright-protected. Any
further use of this Manual by third parties that violate pertinent copyright
provisions is prohibited. Reproduction, translation, electronic and phototechnical
filing/archiving (e.g., photocopying) as well as any amendments require the
written consent of WAGO Kontakttechnik GmbH & Co. KG, Minden, Germany.
Non-observance will involve the right to assert damage claims.
Notes about this Documentation
Designation
2AI 4-20mA HART Ex i
2AI 4-20mA HART NE43 Ex i
5
Validity
From
HW version 04,
SW version 03
All
Manual
Version 1.4.0