Setting Up Via Gsd - WAGO I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-484 2AI 4-20mA HART Ex i
Additional Information about WAGO-I/O-CHECK
You will find a detailed description of the functions and use of the commissioning
tool in the WAGO-I/O-CHECK (759-302) manual on the Internet under:
www.wago.com
8.1.2

Setting Up via GSD

Parameterization via PROFIBUS-PFC200 (750-8206)
• The I/O module cannot be configured in the PROFIBUS process image of
the 750-8206 controller.
• WAGO-I/O-CHECK must be used to change parameters; parameters
cannot be changed using a CODESYS library.
Parameterization via PROFIBUS Fieldbus Coupler/Controller (750-333 or
750-833)
• A GSD file can be used to change parameters.
• WAGO-I/O-CHECK can also be used to change parameters; parameters
cannot be changed using a CODESYS library.
When connecting to a PROFIBUS DP/V1 Fieldbus Coupler (750-333) or
Controller (750-833), assuming that the HART I/O module is supplied in the
default operating mode, the mode must be changed over accordingly. The
parameters for the required operating mode can be set using the GSD files.
Additional Information for Download the GSD Files
The GSD files can be downloaded free of charge from the WAGO website at:
www.wago.com
Before setting the parameters however, the components of the PROFIBUS
system, which define the structure of the input and output process image, must
first be configured.
The configuration software is used to upload and install the GSD files for
PROFIBUS.
They provide the ...
• device characteristic data
• information on their communication capabilities
• other information
Operating Modes 57
Manual
Version 1.4.0