Xilinx VC707 User Manual page 57

The VC707 Evaluation Kit provides the adapter cable shown in
VC707 board from the ATX power supply 4-pin peripheral connector. The Xilinx part number for
this cable is 2600304, and is equivalent to Sourcegate Technologies part number
AZCBL-WH-1109-RA4. For information on ordering this cable, see
X-Ref Target - Figure 1-29
Figure 1-30
X-Ref Target - Figure 1-30
FPGA_PROG_B Pushbutton SW9 (Active-Low)
[Figure
Switch SW9 grounds the FPGA's PROG_B pin when pressed. This action initiates an FPGA
reconfiguration. The FPGA_PROG_B signal is connected to FPGA U1 pin AJ11.
See 7 Series FPGAs Configuration User Guide (UG470)
the 7 series FPGAs.
Figure 1-31
VC707 Evaluation Board
UG885 (v1.8) February 20, 2019
To ATX 4-Pin Peripheral
Power Connector
Figure 1-29: ATX Power Supply Adapter Cable
shows the power connector J18, power switch SW12 and indicator LED DS16.
J18
VCC12_P_IN
1
12V
4
12V
2
N/C
5
N/C
3
COM
6
COM
INPUT_GND
PCIe
Power
Figure 1-30: Power On/Off Switch SW15
1-2, callout 28]
shows SW9.
www.xilinx.com
SW12 U73
1
2
3 1
4
5
6
C471
1μF
25V
3
INPUT_GND
[Ref 3]
Feature Descriptions
Figure 1-29 for powering the
[Ref 27].
To J18 on VC707 Board
UG885_c1_26_030512
VCC12_P
8
C320
330μF
25V
7
6
5
GND
UG885_c1_27_030512
for further details on configuring
Send Feedback
R279
1kΩ
1%
DS16
GND
57