Warning Labels - Epson LS10-B Series User Manual

Setup & Operation 1. Safety

1.7 Warning Labels

The Manipulator has the following warning labels.
The warning labels are attached around the locations where specific dangers exist.
Be sure to comply with descriptions and warnings on the labels to operate and maintain the
Manipulator safely.
Do not tear, damage, or remove the warning labels. Use meticulous care when handling
those parts or units to which the following warning labels are attached as well as the nearby
areas.
Location
A
B
C
D
Location
E
12
Warning Label
Signature label
NOTE
Before loosening the base mounting screws,
hold the arm and secure it tightly with a band to
prevent hands or fingers from being caught in the
Manipulator.
Do not enter the operation area while the
Manipulator is moving. The robot arm may
collide against the operator. This is extremely
hazardous and may result in serious safety
problems.
Hazardous voltage exists while the Manipulator
is ON. To avoid electric shock, do not touch any
internal electric parts.
You can catch your hand or fingers between the
shaft and cover when bringing your hand close to
moving parts.
* Manipulators with bellows do not have this label
for no danger of your hand or fingers being
caught.
NOTE
Manipulator's serial No.
LS10-B Rev.6