Epson LS10-B Series User Manual page 103

Joint #1
(1) A new reduction gear unit contains the
Reduction
Gear Unit
Installation
■ Never adjust (loosen or tighten) the mounting bolts between the flexspline and
cross roller bearing unit. If the mounting bolts are adjusted, the flexspline and
cross roller bearing unit must be aligned by the maker of the reduction gear unit.
CAUTION
(2) Fit the O-rings into the grooves on both
(3) Face the convex side of the circular spline
(4) Match the screw holes on the inner ring of
LS10-B Rev.6
parts shown in the picture on the right
when it is unpacked.
The gear grooves of the flexspline,
circular spline, and the bearings of the
waveform generator have been greased.
Wipe off excess grease from the mounting
surface.
sides of the new circular spline.
Make sure that the rings do not come out
of the grooves.
down, and then fit it into the flexspline.
the cross roller bearing unit and the
through holes of the circular spline.
Maintenance 5. Joint #1
Flexspline and
Cross roller bearing unit
O-ring
Circular spline
Waveform generator
Convex side
Grooves
The other side
91