Epson LS10-B Series User Manual page 93

M/C Cable (1) Turn OFF the Controller.
Removal
(2) Disconnect the following connectors form the controller.
(3) Loosen the screws fixing the plate.
(4) Slide the plate to remove it from the base.
NOTE

(5) As shown on the right, pull out the cables
(6) Disconnect the connectors in the order as
LS10-B Rev.6
Power cable connector Signal cable connector
You do not need to remove them
completely.
For details, refer to Maintenance:
3.3 Connector Plate.
Do not pull the M/C cable after removing the
plate. M/C cables are connected by the
connectors. Doing so may result in
disconnection of the cables.
from the Manipulator.
shown on the right.
Clips of the connectors are△ positions in
the figure.
Push the clip to disconnect the connector.
Maintenance 4. Cable
Finger
screws
4-M3×10
3
1
2
81