Epson LS10-B Series User Manual page 88

Maintenance 4. Cable
Cable Unit (1) Pass the new cables through the Base, cable fixing
Installation
(2) Pass the cables in the User Plate side through the User
(3) As with the wire tie cut off at the removal step (8), bind the cables with a new wire tie.
(4) Connect two connectors inside the Base.
(5) Connect the following to mount base and the Connector Plate.
(6) Connect the ground wire on the Base side to the mount base.
(7) Connect the air tube, D-sub cable, and Ethernet cable (RJ45) to the User Plate.
(8) Fix the ground wire on the User Plate.
(9) Mount the User Plate.
(10) Connect the connectors.
(11) As with the wire tie cut off at the removal step (15), bind the cables with a new wire tie.
(12) Mount the Connector Plate.
(13) Place and secure the Arm Top Cover without the cables being stuck.
76
plate, and nut. Then, rotate the fittings to secure the
cables.
Plate and nut and turn the nut to secure the cables.
Connectors: X41, X211
Air tube, D-sub cable, Ethernet cable (RJ45)
Connectors: X11, X111, X121, CV11, CV12, CV13
For the details, refer to Maintenance: 3.5 User Plate.
Connectors: X22, X33,X42, X43, X44, X51, BR, X221, X231, X241
For the details, refer to Maintenance: 3.3 Connector Plate.
For details, refer to Maintenance: 3.1 Arm Top Cover.
Cable fixing
plate
LS10-B Rev.6
(2)
(1)