Epson LS10-B Series User Manual page 95

M/C cable (1) Set the M/C cable as shown on the right.
Installation
NOTE

(2) Connect the connectors in the order as
(3) Slide the plate to install it.
NOTE

(4) Connect the following connectors to the controller.
(5) Turn ON the Controller.
LS10-B Rev.6
Be careful not to set the plate in wrong
direction.
shown on the right.
Finger screws : 4-M3×10
Tightening torque : 0.6±0.1 N·m
Slide the plate until it will be parallel to the base table.
Be careful not to tighten the screws with the cables get caught on the plate.
Power cable connector Signal cable connector
Maintenance 4. Cable
1
3
2
Finger
screws
4-M3×10
83