Epson LS10-B Series User Manual page 139

(17) Bind the cables with a wire tie in their original positions as before removed in the
(18) Remove the Arm Top Cover.
(19) Check if the Joint #4 moves in a Jog motion by operating from EPSON RC+ menu -
(20) Execute the calibration for Joint #3.
LS10-B Rev.6
removal step (7).
Do not allow unnecessary strain on the cables.
For details, refer to Maintenance: 3.1 Arm Top Cover.
[Tools]-[Robot Manager]-[Jog & Teach].
If the Manipulator oscillates with MOTOR ON and the following errors are detected,
Error 5041: Motor torque output failure in low power state.
Error 4241: Over speed during low power mode was detected.
or when the joint other than Joint #4 moves, the connector for other joint might be
connected to the Joint #4 motor. Check the connector connection.
For details on the calibration method, refer to Maintenance: 13. Calibration.
Maintenance 8. Joint #4
127