Parameter Value Entry - Oval ALTI mass CA00A Instructions Manual

L -- 740 -- 28 -- E

9.3 Parameter Value Entry

The procedure to enter a numerical data of parameters is described here. As an example, reconfiguring
the temperature damping factor from "4.0" to "4.2" is covered in this section. A similar procedure applies
to setting up other parameters.
Click "SEL1".
Click "SEL3". Click "ENT"
Click "ENT" twice.
Click "SEL1" twice.
Click "ENT" once.
Click "SEL1".
Click "ENT". Click "ENT".

(1) Bring up the parameter item subject to setup.
Operate the view until the desired item subject to setup appears.
(For the procedure to view individual items, see 9.2.2 thru 9.2.7 Transition chart.)
When the cursor is moved and located at the desired item, click "SEL1" to bring up the
temperature damping factor setup screen.
(2) Decide whether to modify this parameter or not.
Current setting is shown. If you want to modify it, click "SEL 3" to proceed to the next
screen.
If the current setting is OK, click "ENT" and then "SEL3" to return to the menu select
screen.
Click "ENT".
(3) Numerical data adjustment
To move the cursor to the right, click "ENT".
(As scroll continues, a click next to the rightmost digit brings up a numerical data field
where all digits are highlighted [decision window]; clicking "ENT" further brings the cursor
to the leftmost digit.)
To increment the number, click "SEL1". To continually increment the number, hold "SEL1".
(The number changes in the order "0" ⇒ "1" ⇒ "2" ⇒ "3" ⇒ "4" ⇒ "5" ⇒ "6" ⇒ "7" ⇒" 8"
⇒ "9" ⇒ "." ⇒ "-" ⇒ " ".)
① Move the cursor to the digit of interest.
With a change from "4.0" to "4.2" in mind, move the cursor to the 1st decimal place subject
to data adjustment.
Click "ENT" twice. (The next screen appears.)
② Adjust the numerical value.
With a change from "4.0" to "4.2" in mind, adjust the number in the 1st decimal place from
"0" to "2".
Click "SEL1" twice. (The next screen appears.)
③ Bring up the state ready to finalize numerical value entry.
Click "ENT", readying for finalizing the entry.
(The next screen appears.)
④ Finalize the entry.
Confirm that the desired numerical value is indicated.
Click "SEL1" readying for final confirmation of entry.
(The next screen appears.)
(4) Activate the data entry.
① If the setting "4.2" is definitely OK, click "SEL3".
Setting is now complete. The previous data 4.0 is replaced by 4.2 and the window
returns to the initial menu select screen.
If you want to abort the setting process, click "ENT". (The next screen appears.)
Click "SEL3".
② If you want to abort the setting process, click "SEL3".
A numerical value "4.0" remains unchanged and the window returns to the initial menu
select screen.
Click "SEL3".
Click "SEL3".