Electric Wire Connection Part Of Integral Type / Separate Type Converters - Oval ALTI mass CA00A Instructions Manual

10.4.10 Electric wire connection part of integral type / separate type converters

■ TIIS, NEPSI explosionproof
Use attached cable gland. It is needed to use rubber packing which fits with the outer diameter of using
cable for the cable gland. The cable outer diameters fitting to attached rubber packings are as follows;
Screw Size: G3/4
Packing ID
φ10
φ11
φ12
φ13
φ14
Accessories for Converter Electric Wire Connection Part: 2 pieces, Standard Feature Type Cable Gland
〈Caution〉
◆ Seal off properly not to make the infiltration of rain water and dust from cable, rubber packing, screw
tightening part and so on.
◆ The use of parts other than attached cable gland is prohibited.
◆ Do not install equipment while leaving the connection of blanking plug attached at shipping.
◆ Please refer to our service center if any parts are missing, damaged and so on.
◆ FISCO Explosionproof is not applicable in case of NEPSI Explosionproof
Integral Type Converter
Cable OD
φ9 φ8.1 to φ9.0
φ9.1 to φ10.0
φ10.1 to φ11.0
φ11.1 to φ12.0
φ12.1 to φ13.0
φ13.1 to φ14.0
Screw Size: G3/4
Separate Type Converter
Used for the case of FISCO Explosion-proof
(Only 1 piece for output)
Standard Feature
(4 kinds at the left are attached.)
L -- 740 -- 28 -- E
Unit: mm
Remarks
1