Transition Chart Of View (4) - Oval ALTI mass CA00A Instructions Manual

L -- 740 -- 28 -- E

9.2.5 Transition chart of view (4)

： "SEL1" operation
MODE SELECT
： "SEL3" operation (For operating procedure, see 9.1.2 Switching operation.)
： "ENT" operation
1.Password & Disp
2.Setup
※1
3.Diag/Service
4.Maintenance
Exit
NOTE:
Process screen

1.Flow Param 1.Ana. Output1
2.DensParam 2.Ana. Output2
3.Temp Param 3.Pls. Output1
4.Outputs 4.Pls. Output2
5.Status Output
6.Error Output
Exit
5.Status Input 1.Function
2.Mode
Exit
6.H/L Alarm
1.Assign
2.H/L Alm. Type
3.High Alm. Po.
4.Low Alm. Po.
5.H/L Alm. hys
Exit
Exit
※1：For this function, the setting change is disabled in Write Protect mode (refer to section 9.2).
1.Function
1.Sensor Fail
2.Select
2.Txr Fail
3.Cal Fail
4.Satura. Alm.
5.Param Alm.
6.Txr Alm.
7.Slug Alm.
8.Cal in prog.
9.Fix Output
Exit
3.Drive Output Po.
4.Mode
Exit
1.Analog
2.Pulse
Exit