Pulse Output - Oval ALTI mass CA00A Instructions Manual

9.7.2 Pulse output

A pulse output is available at any frequency desired.
(Simulated output in pulse output 1 is described here in the example below.)
This section covers the procedure to provide a 2100Hz simulated pulse output. A similar procedure applies
to other output settings.
Click "SEL1".
Click "SEL3".
Click "SEL3".
Click "SEL3".
(1) Bring up the item of function you want to use.
Firstly, proceed key operation to show a screen for simulated output of pulse
output 1 (Fix Pulse 1).
(For the procedure to view individual items, see 9.2.2 thru 9.2.7 Transition chart.)
When the cursor is placed over simulated output of pulse output 1 (Fix Pulse 1),
click "SEL1" to bring up simulated output setup screen for pulse output 1.
(2) Decide whether to activate the function or not.
If you want to start simulated output of pulse output 1, click "SEL3" to proceed
to the next screen.
To abort the process without running a simulated output, click "ENT" and then
"SEL3". The window returns to menu select screen.
Click "ENT".
Click "ENT".
(3) Enter a simulated output value.
Set up a simulated output frequency desired.
For the setup procedure, see 9.3 Parameter Value Setup (3).
(In the following screen, a value 2100.00 is finalized.)
(4) Run a simulated output.
If a simulated output "2100.0" is definitely OK, click "SEL3".
If you want to abort the simulated output process, click "ENT" and then click
"SEL3".
The window returns to menu select screen.
Click "ENT".
Click "ENT".
(5) Simulated output of pulse output 1 is now generated.
Output of pulse output 1 is fixed to 2100Hz.
(Unaffected by obtained measurements, error processing or other factors.)
(During the check, GRN LED blinks on and off.)
If you want to cancel the simulate output process, click "SEL3".
Simulated output stops and the window returns to initial menu select screen.
Click "SEL3".
Click "SEL3".
L -- 740 -- 28 -- E