Viewing The Parameters And Description; Viewing The Setup Menu - Oval ALTI mass CA00A Instructions Manual

9.2 View Parameters and Description
Numerous parameters and functions are incorporated in this transmitter.
In 9.2.1 Setup menu window, procedures to bring up MODE SELECT menu screen, the initial screen to
show menu items, are covered. For explanation of individual parameters, see 9.2.2 Transition chart.
9.2.1 View the setup menu
To reconfigure parameters, etc., it is necessary to bring up the MODE SELECT menu screen at first.
The following is the procedure:
CAUTION: Notes on Write Protect mode
Write protect mode is a factory preset mode which restricts parameter changes
or executing functions related to measurement accuracy, performance, and
measurement values of this device to prevent posing problems in case the device
is used for custody transfer, etc.
If the target parameter is changed or the function is executed when the device
is set to Write Protect mode, the message "Write protect" ("Write protected" on
LinkTop) is displayed on the LCD screen or screen of communication terminal
such as LinkTop and the operation is not accepted. For the target parameters of
Write Protect mode, refer to the note "*1" shown in sections 9.2.2 to 9.2.7.
Write Protect mode cannot be set or canceled by customer. If setting/canceling of
this mode is required, please contact the distributor you purchased the product.
Operate "SEL3".
Password is not set.
★
Operate "ENT" 4 times.
Operate "SEL1".
CAUTION: If no command arrives within 5 minutes at "Mode Select" menu screen, it
returns to the normal window.
(1) Bringing up "MODE SELECT" screen
Repeat "ENT" operation until "MODE SELECT" screen appears.
(For detail of operation, see 9.1.2 Switch operation.)
Shown at left is the "MODE SELECT" screen.
(2) Operation on menu view
Click "SEL3". A switch to "MODE SELECT menu" screen takes place.
(If password is enabled, a password setup screen appears.)
(See 9.5 Password Function which will guide you the rest of the way.)
Password is set.
★
3) "MODE SELECT" menu screen appears.
From this screen, you are ready to configure parameters and to run various
functions.
For view parameters and description, see the respective item in 9.2.2 thru 9.2.7
Transition charts.
To return to the normal screen without proceeding to setup process, operate
"ENT" 4 times and select Exit.
Then, operate "SEL1" to return to the normal screen.
(4) Normal screen appears.
Password setup screen
For the rest of the way, see 9.5 Password
Functions.
L -- 740 -- 28 -- E
1