Table of Contents
Advertisement
Figure 137. Installing the left control panel
3
Connect the control panel cable to the system board connector.
Next steps
1
Install the
cable chain
2
Close the drive bays.
3
Place the system into the rack. For more information, see the Rail Installation Guide available at www.dell.com/poweredgemanuals.
4
Install the
power supply
5
Open the drive
bays, install
6
If removed,
install the front bezel.
7
Follow the procedure listed in
Removing the right control panel
Prerequisites
1
Follow the safety guidelines listed in
2
Power off the system and all attached peripherals.
3
Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
4
Open the drive
bays, remove
5
Remove the
power supply
6
Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
7
If installed,
remove front
8
Remove the system
cover.
168
Installing and removing system components
assembly.
units.
all
drives, and then
close the drive bays.
After working inside your
Safety instructions.
all
drives, and then
units.
bezel.
system.
close the drive bays.
Advertisement
Table of Contents
