Installing the left control panel
Prerequisites
Follow the safety guidelines listed in
Steps
1. Route the control panel cable through the side wall of the system.
2. Align the left control panel assembly with the control panel slot on the system and place the assembly in the slot on the system.
3. Connect the control panel cable to the system board connector and secure it using cable latch.
4. Using a Phillips #1 screwdriver, install the screws that secure the control panel and cable tube to the system.
Figure 169. Installing left control panel
Next steps
1.
Install the air
shroud.
2.
Install the cooling fan
assembly.
3. Follow the procedure listed in
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the air
shroud.
4.
Remove the cooling fan
Steps
1. Disconnect the VGA cable from the system board.
2. Pull the cable latch and disconnect the control panel cable from the system board connector.
3. Using Phillips #1 screwdriver, remove the screws that secure the control panel and cable tube to the system.
4. Holding the control panel and cable tube by its sides, remove the control panel and cable tube away from the system.
206
Installing and removing system components
Safety
instructions.
After working inside your
Safety
instructions.
Before working inside your
assembly.
system.
system.