Table of Contents
Advertisement
Figure 23. Installing the drive backplane cover
Next steps
1. Follow the procedure listed in
Control panel
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the drive backplane
4. If installed,
remove the air
5.
Remove the cooling fan
6.
Remove the side wall
bracket.
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel and the right control panels cable cover to the
system and remove the cable cover away the system.
2. Disconnect the right control panel cable and the VGA cable from the connectors on the system board.
3. Holding the cable, slide the right control panel out of the system.
NOTE:
Observe the routing of the cable as you remove the right control panel from the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
After working inside your system
Safety instructions
Before working inside your system
cover.
shroud.
assembly.
on page 47.
on page 46.
on page 47.
Installing and removing system components
53
Advertisement
Table of Contents
