Table of Contents
Advertisement
Figure 136. Removing the left control panel
Next step
Replace the left control
panel.
Installing the left control panel
Prerequisites
1
Follow the safety guidelines listed in
2
Power off the system and all attached peripherals.
3
Disconnect the system from the electrical outlet, and disconnect the peripherals.
4
Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5
If installed,
remove the front
6
Open the drive
bays, remove
7
Remove the
power supply
8
Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
9
Remove the system
cover.
10
Remove the
cable chain
Steps
1
Align the left control panel assembly with the control panel slot on the chassis and using Phillips #1 screwdriver, replace the screws to
secure the left control panel assembly to the chassis.
2
Route the left control panel cable through the cable channel of the system.
Safety
instructions.
bezel.
all
drives, and then
close the drive bays.
units.
assembly.
Installing and removing system components
167
Advertisement
Table of Contents
