Figure 106. Installing the Serial COM port
Next steps
1. Reconnect the serial COM port cable to the connector on the rear I/O board.
2.
Install the expansion card
3. Follow the procedure listed in
Optional IDSDM module
Removing the IDSDM module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If you are replacing the IDSDM module,
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards
into the corresponding slots.
Steps
Holding the blue pull tab, lift the IDSDM module out of the system.
riser.
After working inside your system
Safety instructions
Before working inside your system
remove the MicroSD
on page 47.
on page 46.
on page 47.
cards.
Installing and removing system components
147