Optional Idsdm Module; Removing The Idsdm Module - Dell EMC PowerEdge R7525 Installation And Service Manual

Figure 109. Installing the Serial COM port
Next steps
1. Reconnect the serial COM port cable to the connector on the rear I/O board.
2. Install the expansion card
3. Follow the procedure listed in

Optional IDSDM module

Removing the IDSDM module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If you are replacing the IDSDM module,
NOTE: Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
the corresponding slots.
Steps
Holding the blue pull tab, lift the IDSDM module out of the system.
riser.
After working inside your system
Safety instructions
Before working inside your system
remove the MicroSD
on page 27.
on page 26.
on page 27.
cards.
Installing and removing system components 131