Installing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove expansion card
4. Disconnect the serial COM port cable from the connector on the rear I/O board.
Steps
1. Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser (Riser 3).
NOTE:
For more information about how to remove the filler bracket, see the
expansion card riser
2. Slide the serial COM port into the expansion card riser.
3. Connect the serial COM port cable to the serial port.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 76. Installing the serial COM port
Next steps
1. Reconnect the serial COM port cable to the connector on the rear I/O board.
2.
Install the expansion card
3. Follow the procedure listed in
Optional IDSDM module
98
Installing and removing system components
Safety
instructions.
Before working inside your
riser.
topic.
riser.
After working inside your
system.
system.
Removing the expansion card from the