Lightware UMX4x4-Pro2 User Manual page 33

View locked outputs in TAKE mode
Step 1. Select the desired layer. (Video or audio or both of them)
Step 2. Press and release the Output Lock button.
Step 3. The Output Lock button starts to blink and all the buttons of any locked
Lock an output in TAKE mode
Step 1. Select the desired layer. (Video or audio or both of them)
Step 2. Press and release the Output Lock button.
Step 3. Now the Output Lock button starts to blink and all the locked output's buttons
Step 4. If no button is pressed for three seconds, the router returns to idle state.
Step 5. If an unlit output button is pressed, it starts to blink, to indicate that it is
Step 6. Press and release TAKE button. The selected destinations are now locked.
Unlock an output in TAKE mode
Step 1. Select the desired layer. (Video or audio or both of them)
Step 2. Press and release the Output Lock button.
Step 3. Now the Output Lock button starts to blink and all the locked output's buttons
Step 4. If no button is pressed for three seconds, the router returns to idle state.
Step 5. If an illuminating output button is pressed, it goes off, to indicate that it is
Step 6. Press and release the TAKE button. The deselected destinations are now
View locked outputs in AUTOTAKE mode
In AUTOTAKE mode a destination is selected all the time. Therefore the currently
selected output and input buttons are illuminated. The Output Lock button illuminates
regarding to the lock state of the current output.
Viewing all locked outputs is not possible in AUTOTAKE mode, as pressing the Output
Lock button instantly locks or unlocks the current output.
Lock an output in AUTOTAKE mode
Step 1. Select the desired layer. (Video or audio or both of them)
Step 2. Press and release the required destination button. Now the selected destination
Step 3. Press and release the Output Lock button. Now the Output Lock button lights up
Unlock an output in AUTOTAKE mode
Step 1. Press and release the required destination button which was previously locked.
Step 2. Press and release the Output Lock button (deselect). Now the Output Lock button
Section 5. Operation
destinations light up, and remain illuminated for three seconds.
illuminate green (view state).
preselected for output locking.
illuminate green (view state).
preselected for unlocking.
unlocked.
button and the currently configured source button light up (view mode).
in red, and lock function is activated at once. No source can be changed at the
locked destination.
Now the selected destination button and the currently configured source button
and the Output Lock button light up.
turns off, and the locking function has been cancelled.
UMX4x4-Pro2
User's Manual
Page 33 / 136