Factory Defaults; Enable / Disable Ricod - Lightware UMX4x4-Pro2 User Manual

4.5.4. Factory defaults

After firmware upgrade the Slave mode is always enabled (commands from the Master
devices are accepted and executed) and the Master mode is always disabled. This state
will be caused by reloading the factory defaults with {FACTORY=ALL}, protocol
command. For more information about reloading the factory defaults see the user's
manual of the devices.

4.5.5. Enable / disable RICOD

Users can enable or disable the RICOD function for each input and output video port
separately. For example, one can enable the RICOD on the 1
and the 1
output ports. Figure 4-2 shows this case. Video ports where RICOD is enabled are green.
The RICOD can be enabled or disabled by LW2 protocol commands for every Lightware
device. (For more information see section
Another way to change RICOD state is available for devices which have front panel LCD.
In this case users can change settings with front panel operation. The section RICOD
master on page
RICOD.
Section 4. Technologies

Slave - If a device receives RICOD commands over its video outputs it works as
a Slave, like the device on the left side. In this case the devices are capable of
receiving commands over their outputs (e.g. connected to another Lightware
device) if the function is enabled. This means that the remote device is capable of
being controlled from that given output. (The command affects only that output
where the RICOD command was received). The Lightware transmitters (e.g.
WP-UMX-TP-TX100) work as RICOD Slaves typically.
Lightware RICOD
capable device
Inputs
st rd
and the 3 video output port. RICOD is disabled on the other video input and
Lightware RICOD capable device
Inputs
I1
I2
I3
I4
Master
42 introduces the UMX4x4-Pro2 front panel menu contents affected by
Video
Outputs
RICOD
Slave
Legend:
Outputs
RICOD is enabled (can control)
I
O1
over this input port
RICOD is enabled (can be controlled)
O
over this output port
O2
RICOD is disabled (cannot control)
I
over this input port
O3
RICOD is disabled (cannot be controlled)
O
over this output port
O4
Slave
Figure 4-2. Enabling RICOD
RICOD related commands
UMX4x4-Pro2
User's Manual
RICOD capable
device's Input
Inputs
Master
st nd
and the 2 video input
on page 113.)
Page 25 / 136