Lightware UMX4x4-Pro2 User Manual page 10

 Universal power supply – UMX4x4-Pro2 matrices accept AC voltages from 100 to 240
 Power failure memory – In case of power failure, the unit stores its latest configuration,
 HDCP compliant – UMX4x4-Pro2 matrices comply with HDCP1.2 standard. Lightware is
 20 meter input cable compensation – Using 22AWG high quality DVI or HDMI cable,
 Pixel Accurate Reclocking – (removes jitter caused by long cables) Each output has a
 Frame detector and signal analysis – Using the built-in webpage or Lightware Device
 DVI/HDMI conversion – The router is able to convert from HDMI to DVI signals so that
 Fiber cable support – Self powered DVI fiber cables using +5V from DVI sources (VGA
 Zero frame delay – Even on Analog Inputs - Lightware's UMX4x4-Pro2 matrix
 Separate Audio and Video matrix switching – Video and audio signals can be
 Analog Audio and Video A/D conversion – UMX4x4-Pro2 matrices convert
 Accepts analog and digital audio signals – UMX4x4-Pro2 accepts unbalanced analog
Page 10 / 136
Volts with 50 or 60 Hz line frequency on standard IEC connector.
and after next power up it loads automatically.
a legal HDCP adopter. The included Advanced HDCP Management
eliminates the need for re-authentication upon switching.
the inputs are automatically compensated for up to 20 meter cable
length, which extends installation possibilities even at the highest
HDTV or computer resolutions.
clean, jitter free signal, eliminating signal instability and distortion
caused by long cables or connector reflections.
Controller (LDC) software the user can monitor incoming signal
parameters such as resolution, signal timing parameters, audio type,
scan rate, HDCP encryption and so on.
you can watch HDMI videos on your computer display without audio.
cards, etc.) usually consume more than 50 mA, which load is
maximum allowed by DVI 1.0 standard. UMX4x4-Pro2 supports +5V
500 mA constant current output on each DVI output to power long
distance fiber optical cables.
switchers add no frame delay to the switched signal. There is no
frame or line period delays to the signals when passing a Lightware
router.
separated and switched independently. Even if the HDMI stream
contains embedded audio.
uncompressed analog audio and video signal to digital and the digital
or digitized analog audio can be embedded in the video stream.
stereo; 5.1 S/PDIF and even 7.1 HDMI embedded audio signals.
Section 2. General description