Mixing Fan - Danfoss VLT FC Series Service Manual

D2h/D4h/D7h/D8h/J9 Unit Dis...

11.2.10 Mixing Fan

The mixing fan snaps into a slot in the power terminal mounting plate. To remove or reinstall the mixing fan, use the
following steps. See Illustration 11.5.
Disassembly
1. Place the end of a screwdriver under each of the
mixing fan release tabs. Press in and lift to free
the fan and housing from the power terminal
mounting plate.
2. Unplug the mixing fan cable connector. Tape the
free end of the fan cable to the mounting plate
so that it does not fall back into the drive.
3. Remove the mixing fan from the fan housing.
11 11
198
®
VLT FC Series, D1h–D8h, Da2/Db2/Da4/Db4, E1h–E4h, J8/J9
Reassembly
1.
2.
3.
4.
Danfoss A/S © 02/2019 All rights reserved.
Connect the fan cable to the mixing fan cable
connector.
Position the mixing fan in the fan housing.
Position the fan and housing in the fan slot on
the power terminal mounting plate.
Press the mixing fan into the slot until the release
tabs snap into place.
MG94A502