Top Fan - Danfoss VLT FC Series Service Manual
Hide thumbs
Also See for VLT FC Series:
- Operating instructions manual (64 pages) ,
- Operating manual (26 pages) ,
- Installation manual (12 pages)
Table of Contents
Advertisement
E1h–E4h Drive Disassembly a...
13.2.24 Top Fan
To remove or reinstall the top fan, use the following steps. Refer to Illustration 13.30.
Disassembly
1.
Remove 2 screws (T25) from the fan housing.
2.
Slide the fan housing and fans out from under
the retaining clips.
3.
Unplug the in-line connector attaching the fan
cable. Feed the cable through the cable access
hole.
4.
Lift the fans from the pins in the fan housing.
MG94A502
Service Guide
Reassembly
Tighten fasteners according to chapter 14.1 Fastener Torque
Ratings.
1.
2.
3.
4.
5.
Danfoss A/S © 02/2019 All rights reserved.
Place the fans over the pins in the fan housing,
with the fan arrows pointing away from the drive.
Feed the fan cables through the cable access hole
on the top plate.
Reconnect the in-line cable connector.
Slide the fan housing and fans into position
under the retaining clips.
Secure 2 screws (T25) in the fan housing.
13
13
309
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the VLT FC Series and is the answer not in the manual?
Questions and answers
How do I clear log S:28[M26] in my danfoss vfd
How can clear log S:28[M26]in my danfoss vfd
To clear log S:28[M26] in your Danfoss VLT FC Series VFD, reset the unit. This clears alarms and warnings, as noted for similar faults like ALARM 78. Make sure the issue causing the log has been resolved before resetting.
This answer is automatically generated