Conventions; Document Version; Approvals And Certifications; Disposal - Danfoss VLT FC Series Service Manual

Introduction

1.4 Conventions

•
Numbered lists indicate procedures.
•
Bulleted lists indicate other information.
•
Italicized text indicates the following:
- Cross-reference
- Link
- Parameter name
- Parameter option
- Parameter group name
•
All dimensions in drawings are in mm (inch).
•
An asterisk (*) indicates default setting of a
parameter.

1.5 Document Version

This guide is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.2 shows
the document version and comments about changes made
to the edition.
Edition
MG94A5xx
illustrations for D1h–D8h drives.
D9h–D10h/E5h–E6h drive modules,
and data for 200–240 V (T2) drives.
Table 1.2 Document Version

1.6 Approvals and Certifications

The following list is a selection of possible type approvals
and certifications for Danfoss drives:
MG94A502
Service Guide
Remarks
Updated procedures and
Added content for J8–J9 drives,
Danfoss A/S © 02/2019 All rights reserved.
NOTICE
The specific approvals and certification for the drive can
be found on the nameplate. For more information,
contact the local Danfoss office or partner.
For more information on UL 508C thermal memory
retention requirements, refer to the section Motor Thermal
Protection in the product-specific design guide.
For more information on compliance with the European
Agreement concerning International Carriage of Dangerous
Goods by Inland Waterways (ADN), refer to section ADN-
compliant Installation in the product-specific design guide.

1.7 Disposal

Do not dispose of equipment containing
electrical components together with
domestic waste.
Collect it separately in accordance with
local and currently valid legislation.
1 1
089
11