Heat Sink Access Panel; Removing The Heat Sink Access Panel - Danfoss VLT FC Series Service Manual

D1h/D3h/D5h/D6h/J8 Drive Di...

10.4 Heat Sink Access Panel

10.4.1 Removing the Heat Sink Access Panel

The drive has an optional access panel for accessing the heat sink. To remove or reinstall the heat sink access panel, use the
following steps. Refer to Illustration 10.34.
Disassembly
1. Do not power the drive while removing the heat
sink access panel.
2. If the drive is mounted on a wall, or its back is
otherwise inaccessible, reposition it to provide full
access.
3. Remove the internal hex screws (3 mm)
connecting the access panel to the back of the
enclosure. There are 5 or 9 screws depending on
the size of the drive.
10 10
184
®
VLT FC Series, D1h–D8h, Da2/Db2/Da4/Db4, E1h–E4h, J8/J9
Reassembly
Tighten fasteners according to chapter 14.1 Fastener Torque
Ratings.
1.
2.
3.
Danfoss A/S © 02/2019 All rights reserved.
Do not power the drive while removing the heat
sink access panel.
If the drive is mounted on a wall, or its back is
otherwise inaccessible, reposition it to provide full
access.
Fasten the internal hex screws (3 mm) connecting
the access panel to the back of the enclosure.
There are 5 or 9 screws depending on the size of
the drive.
MG94A502