Danfoss VLT FC Series Service Manual page 8

Contents
11.3 D7h/D8h Disassembly and Assembly
11.4 Heat Sink Access Panel
12 Da2/Db2/Da4/Db4 Parallel System Disassembly and Assembly
12.1 Before Proceeding
12.2 Parallel Drive System Disassembly and Assembly
12.3 Parallel Drive Module Disassembly and Assembly
6
®
VLT FC Series, D1h-D8h, Da2/Db2/Da4/Db4, E1h-E4h, J8/J9
11.2.4 Power Card
11.2.5 AC Input Busbars
11.2.6 Mains Input Terminal Block
11.2.7 EMC Shield
11.2.8 Brake Terminal Block (Optional)
11.2.9 Motor Terminal Block
11.2.10 Mixing Fan
11.2.11 Power Terminal Mounting Plate
11.2.12 Current Sensors
11.2.13 Balance/High Frequency Card
11.2.14 Gate Drive Card
11.2.15 Inrush Card
11.2.16 SCR Input Busbars
11.2.17 SCRs
11.2.18 DC Bus Rails
11.2.19 IGBTs
11.2.20 Standard DC Capacitors
11.2.21 Standard DC Capacitor Bank Layouts
11.2.22 Twistlock DC Capacitors
11.2.23 Twistlock DC Capacitor Bank Layouts
11.2.24 Brake IGBT Module
11.2.25 Heat Sink Fan
11.2.26 Door Fan
11.2.27 Top Fan
11.3.1 Removing the Drive from the Extended Options Cabinet
11.3.2 Accessing the Heat Sink Fan in D7h/D8h Drives
11.3.3 Contactor
11.3.4 Disconnect
11.4.1 Removing the Heat Sink Access Panel
12.1.1 Lifting the Unit
12.2.1 Removing the Control Shelf
12.2.2 Removing a Drive Module
12.2.3 Installing the Drive Modules
12.2.4 Installing the Control Shelf
Danfoss A/S © 02/2019 All rights reserved.
190
192
194
196
196
197
198
200
201
203
205
207
209
209
211
214
216
220
224
228
230
232
235
237
240
240
240
242
242
244
244
246
246
247
249
249
250
251
253
255
MG94A502