New Holland CX720 Repair Manual page 1612

ENGINE - Remove (B.10.A - F.10.A.10)
CX860, CX880
NOTE: The engine and cooling system used in the CX Combine is designed to be removed as a modular unit. The
following engine removal procedure demonstrates the removal of the engine only from the module. This procedure
takes into consideration the possible unavailability of proper, or sufficient lifting equipment for complete module re-
moval. When possible, remove the engine and cooling system module as designed. This procedure covers the Iveco
8 Liter (F2B) and 10 Liter (F3A) engines. While some illustrations may not represent each engine exactly, the proce-
dure is essentially the same for both versions.
1. Remove the gearbox and hydraulic pumps from
the engine. (Refer to PROCESS DRIVE Primary
process drive - Remove (C.50.B - F.10.A.10))
Place a suitable container (1) below the coolant drain
hose (2).
NOTE: The Iveco engine cooling system has a coolant ca-
pacity of 42 liters (11.1 gal.). Be sure to use clean con-
tainers with adequate capacity when draining the cooling
system.
2. Turn the drain petcock (1) on the radiator (2) counter
clockwise to open the coolant drain. Drain all of the
coolant into the containers.
3. Remove the cap (1) and turn the engine oil drain
valve (2), to the open position. Drain all of the engine
oil into suitable containers.
NOTE: The Iveco 8 Liter engine has an oil capacity of 24
liters (6.34 gal. ). The Iveco 10 Liter engine has an oil
capacity of 29 liters (7.7 gal.). Be sure to use clean con-
tainers with adequate capacity when draining the engine
oil.
POWER PRODUCTION - ENGINE
2 4/7/2006
B.10.A / 66
1
10013105_834
2
10013106_835
3
10013107_836