New Holland CX720 Repair Manual page 1625

ENGINE - Remove (B.10.A - F.10.A.10)
CX720, CX740, CX760, CX780, CX820, CX840
NOTE: The engine and cooling system used in the CX Combine is designed to be removed as a modular unit. The
following engine removal procedure demonstrates the removal of the engine only from the module. This procedure
takes into consideration the possible unavailability of proper, or sufficient lifting equipment for complete module re-
moval. When possible, remove the engine and cooling system module as designed.
1. Remove the gearbox and hydraulic pumps from
the engine. (Refer to PROCESS DRIVE Primary
process drive - Remove (C.50.B - F.10.A.10))
Place a suitable container (1) below the coolant drain
hose (2).
NOTE: The cooling system has a coolant capacity of 31.5
liters(8.3 gal. ). Be sure to use clean containers with ad-
equate capacity when draining the cooling system.
2. Turn the drain petcock (1) on the radiator (2) counter
clockwise to open the coolant drain. Drain all of the
coolant into the containers.
3. Remove the cap (1) and turn the engine oil drain
valve (2), to the open position. Drain all of the engine
oil into suitable containers.
NOTE: The New Holland engine has an oil capacity of 23
liters (6.07 gal. ). Be sure to use clean containers with
adequate capacity when draining the engine oil.
POWER PRODUCTION - ENGINE
2 4/7/2006
B.10.A / 79
1
10013105_780
2
10013106_781
3
10013107