Safety And Handling - Waters ACQUITY Refractive Index Detector Overview And Maintenance Manual

4 Maintenance Procedures

Safety and handling

Bear in mind these advisories when you perform maintenance operations on
the system.
Warning:
compounds that are toxic, wear clean, chemical-resistant,
powder-free gloves when handling components.
Warning:
including inhalation, always wear chemical-resistant, powder-free
gloves and observe Good Laboratory Practice when you handle them.
See the Material Safety Data Sheets for the solvents you use.
Warning:
the refractive index detector. The panels cover components that are
serviceable only by Waters technicians.
Caution:
system module, do not disconnect an electrical assembly from the
module while the module remains connected to the ac supply source.
Follow this procedure to completely interrupt power to the module:
1.
2.
Afterward, wait 10 seconds before disconnecting any assembly from the
module.
See Appendix A
74 October 13, 2014, 715003547 Rev. C
To avoid personal contamination with biohazards or
To avoid the harmful effects of personal contact with solvents,
To avoid electric shock, do not remove protective panels from
To avoid damaging the electronic components or circuitry of a
Set the module's power switch to Off.
Disconnect the module's electrical supply cord from the ac source.
for safety advisory information.