Stacking The Modules - Waters ACQUITY Refractive Index Detector Overview And Maintenance Manual

2 Preparing the detector

Stacking the modules

Warning:
without assistance.
To stack the modules:
1. Place the rear feet of the detector atop the previously added module in
the system stack, and slide it backward until its rear alignment pin rests
in the rear alignment slot on the module.
2. Lower the front of the detector so that its front alignment pin rests in
the front alignment slot on the previously added module.
3. Repeat
38 October 13, 2014, 715003547 Rev. C
To avoid back injuries, do not attempt to lift the detector
step 1 and step 2 for the remaining system modules.
Alignment pin (2)
Alignment slot (2)