2 Preparing the detector
4.
Align the leak sensor's T-bar with the slot in the side of the leak sensor
reservoir, and slide the leak sensor into place.
5.
Plug the leak sensor connector into the port on the front of the detector.
Leak sensor connector port on front of detector:
6.
Power-on the detector.
7.
In the console, select ACQUITY System from the system tree.
8.
Click Control > Leak sensors.
9.
Enable the detector leak sensor.
40
October 13, 2014, 715003547 Rev. C
TP03559
T-bar
Slot in leak
sensor reservoir