Table of Contents
Advertisement
3 Using the detector
Caution:
of a system module, do not disconnect an electrical assembly from
the module while the module remains connected to the ac supply
source.
Follow this procedure to completely interrupt power to the module:
Afterward, wait 10 seconds before disconnecting any assembly
from the module.
2.
Power-off the refractive index detector.
3.
Open the refractive index detector's door, gently pulling its right-hand
edge toward you.
4.
Locate the source of the leak, if external to the unit, and make the
repairs necessary to stop the leak.
5.
Remove the leak sensor from its reservoir, holding it by its serrations
and pulling upward.
Leak sensor:
If you cannot easily manipulate the leak sensor after removing it
Tip:
from its reservoir, detach the connector from the front of the device (see
page
76).
64
October 13, 2014, 715003547 Rev. C
To avoid damaging the electronic components or circuitry
1.
Set the module's power switch to Off.
2.
Disconnect the module's electrical supply cord from the ac
source.
Serrations
Advertisement
Table of Contents
