Brother NV4000D Service Manual page 283

Embroidery
26
X belt presser attachment
1. Attach the X belt presser 1 to the X carriage assembly , and then
temporarily tighten the screw 1.
*Key point
• Hold the X belt with the X belt presser, and align the ridge with
the trough.
2. Slide the XY carriage assembly left and right to check that the belt is
secured to the X belt presser, and then fully tighten the screw 1.
Start movie clip (CD-ROM version only)
1
27
X sensor PCB assembly attachment
1. Slide the X carriage assembly of the main frame assembly to the right as
far as possible.
2. Attach the X sensor PCB assembly to the X guide plate 1 with the screw
1.
*Key point
• Engage the positioning tab at the left end of the X guide plate
with the positioning notch on the X sensor PCB assembly.
1
Main parts
Screw, Pan (S/P washer)
M4X8
1.18 – 1.57 N
Color; Silver
Screw, Bind
M3X6
0.59 – 0.79 N
Color; Silver
Torque
·
m
Torque
·
m
1
1
1 1
3 - 151