Brother NV4000D Service Manual page 282

Embroidery
25
XY carriage unit attachment
1. Insert the X guide plate 2 of the main frame assembly into the groove on
the X slider 1.
2. Place the left end of the X guide shaft 3 over the left bushing4 of the
main frame assembly.
3. Position the tab on the right end of the X guide shaft 3 at an angle, and
then insert the tab downward at an angle relative to the right bushing 5.
4. Hold both ends of the X guide shaft 3, and then rotate the shaft away from
the operator to secure it.
5. Tighten the screws 1 at both ends of the X guide shaft 3.
Start movie clip (CD-ROM version only)
1
3 - 150
Main parts
Screw, Pan (S/P washer)
M4X8
Color; Silver
Torque
·
1.18 – 1.57 N m
2 1
4
3
5
1