Module
9
Thread release lever assembly attachment
1. Apply a small bead of MOLYKOTE EM-30L to the calking shaft (center)
2 of the thread release lever 1.
2. Insert the calking shaft (center) 2 of the thread release lever 1 into the
shaft hole on the unit holder, and then attach the retaining ring (E3).
*Key point
• Position the thread release lever with the hole down.
3. Apply a bead of MOLYKOTE EM-30L to the calking shaft (lower) 3 of
the thread release lever 1.
Apply MOLYKOTE EM-30L to the calking shaft (center)
of the thread release lever.
Apply MOLYKOTE EM-30L to the calking shaft (lower)
of the thread release lever.
Start movie clip (CD-ROM version only)
Needle-presser module
Small bead
Bead
1
2
3
Retaining ring E3
3 - 111